Download User Guide - DM3600U

15.0 FAULT FINDING
ALSO AVAILABLE:
POSSIBLE CAUSE
ACTION
No power
Check power supply connections
DISPLAY SHOWS
Input is out of range
(above maximum)
Check that the engineering high value is
correct
DISPLAY SHOWS
Input is out of range
(below minimum)
Check that the engineering low value is
correct
The displayed value (excluding
total) is greater than 6 digits
(i.e. 999999)
This can occur if the PV is configured
outside of the displayable range
SYMPTOM
DISPLAY IS BLANK
‘DP Err’ IS DISPLAYED
‘OP CAL’ IS DISPLAYED
The output pod has been corrupted Re-configure output. If the error is still
present replace the output pod
‘IP CAL’ IS DISPLAYED
The input calibrated data has been Re-input calibration data. If the error is
corrupted
still present replace the unit
Smart In Head Temperature Transmitters
DIN Rail Mounted Temperature Transmitters
Panel & Field Temperature Indicators
Temperature Probes
Trip Amplifiers
Signal Conditioners
And many other products
For further information on all products:
Status Instruments Ltd, Green Lane Business Park, Tewkesbury, Glos. GL20 8DE
Tel: +44 (0)1684 296818
Email: [email protected]
Page 23
Page 24
Fax: +44 (0)1684 293746
Web: www.status.co.uk