Download Frontline LAN Troubleshooting Guide

Transcript
Frontline LAN troubleshooting guide
bridge forwarding table, or from broadcast-based protocols like
ARP, and not often from truly unknown destinations. Many unwary
technicians have seen the traffic distribution (nearly 100 percent
broadcasts) but failed to noticed the exceptionally low utilization
level. This results in the incorrect diagnosis of a broadcast storm
present, or that their network is experiencing unbelievably high
broadcast rates as a part of normal operation.
Access control
An increasingly popular form of access control is the 802.1X
protocol, which supports various authentication methods for
gaining access to the host network. Each station connecting to
the switch must authenticate before it is joined to the broadcast
domain. There are many ways this can be implemented, including:
fully locking the station out, placing the station in a “holding”
state on an isolated broadcast domain until the authentication
challenge is satisfied, and placing the station on an unsecured
broadcast domain with Internet access but no local access unless
it is authenticated. Implementation of 802.1X will result in passive
monitoring challenges that include, but are far from limited to:
No traffic at all. No traffic is forwarded to the port by the switch
until the attached station issues an authentication request, and
then only authentication traffic will be observed until the station
satisfies the authentication requirements.
Very little traffic. Only a limited subset of traffic may be observed
until the station is authenticated. The specific types of traffic that
may be seen falls into the “it depends” category, and will be
different for each network, and possibly for different connection
points within the network. A very limited list of the many
possibilities includes:
Fluke Networks
74