Download Frontline LAN Troubleshooting Guide
Transcript
Frontline LAN troubleshooting guide bridge forwarding table, or from broadcast-based protocols like ARP, and not often from truly unknown destinations. Many unwary technicians have seen the traffic distribution (nearly 100 percent broadcasts) but failed to noticed the exceptionally low utilization level. This results in the incorrect diagnosis of a broadcast storm present, or that their network is experiencing unbelievably high broadcast rates as a part of normal operation. Access control An increasingly popular form of access control is the 802.1X protocol, which supports various authentication methods for gaining access to the host network. Each station connecting to the switch must authenticate before it is joined to the broadcast domain. There are many ways this can be implemented, including: fully locking the station out, placing the station in a “holding” state on an isolated broadcast domain until the authentication challenge is satisfied, and placing the station on an unsecured broadcast domain with Internet access but no local access unless it is authenticated. Implementation of 802.1X will result in passive monitoring challenges that include, but are far from limited to: No traffic at all. No traffic is forwarded to the port by the switch until the attached station issues an authentication request, and then only authentication traffic will be observed until the station satisfies the authentication requirements. Very little traffic. Only a limited subset of traffic may be observed until the station is authenticated. The specific types of traffic that may be seen falls into the “it depends” category, and will be different for each network, and possibly for different connection points within the network. A very limited list of the many possibilities includes: Fluke Networks 74