Download Installation Manual

Slip Ring Connections
This assumes brake cable and down cable are in
position and are fitted through top hat assembly
•
Using
two 17mm spanners attach the slip ring
brushes to the frame. Again be careful not to over
tighten as the tube can break
•
Loosen
the 3 stud nuts on top of the slip ring
unit and connect the down cable ends at the top
hat to the 3 studs. Tighten the stud nuts with a
13mm spanner. Do not over tighten as you may
shear the copper stud.Vibration washers are
included to ensure a secure fit.
Note: Any cable can be connected to any stud.
•
With
a 10mm socket loosen the bolts on the
brushes till the brushes can be moved freely.
Position the brushes in the middle of the rings.
Adjust for good contact and then tighten bolts.
•
onnect the generator lead out wires to the top
C
of the brushes and tighten using a 10mm socket.
19