Download User Manual - Gill Instruments

Transcript
Contents
2.2.5
Digital Rain Gauge Connections
Rain Gauge
Cable Entry
Gland.
Rain Gauge
Connections
J8 Terminal 2
J8 Terminal 1
Rain Gauge Digital Switch Connection (DIG 1)
J8 Hub Box
2 Way Terminal Block
Terminal
Signal Names
Nos.
DIG 1
GND
Chassis
Ground
Figure 10
Digital Switch e.g.
Rain Bucket
Supplied 6M Cable
2
1
Terminal
Post
Clear
Black
Signal Names
Switch Contact
Return Switch Contact
Screen Wire
Chassis Ground
MetPak RG DIG 1 Rain Gauge Connections
To connect the Rain Gauge 6 Metre lead to the Hub Box.
Last Change
12 March, 2013
1.
Open MetPak RG’s hub box by unfastening the four screws.
2.
Locate connector J8 (see Figure 3).
3.
Pass the cable through one of the gland nuts (see Note below).
4.
Connect the cable as detailed in Figure 10.
5.
Attach the cable’s screen wire to a terminal post.
6.
After connection, securely tighten the gland nut to prevent moisture ingress.
7.
NOTE: The MetPak RG Hub Box cable glands contain spring loaded metal
leaves that are designed to make a ground contact with cables that have an
overall braid screen. Care is therefore required when inserting and removing
cables through the glands to prevent damage to the metal leaves.
MetPak RG User Manual
© Gill Instruments Ltd
Page 13