Download DEMONSTRATOR USER MANUAL

Transcript
USECA
USECA Demonstrator V1.1: User
Page 4 of 4
Instructions for use of the Demonstrator
Installation
Installation Requirements
The following software and hardware prerequisites are required for a proper run of the USECA
demonstrator application.
•
Operating system: Windows 95 (OSR2), Windows 98 or Windows NT Version 4.0.
•
Hardware requirements:
•
Video resolution:
•
it is recommended to set the colour palette > 256 colours
•
G&D Personal Chipcard Terminal PCT200
1024*768 pixel
Installation of the Demonstrator Application
If version 1.0 of the USECA demonstrator application has already been installed on the PC or
laptop this older version has to be de-installed before the newer version 1.1 can be installed. In
order to de-install the application please refer to section 2.1.3.
The USECA demonstrator application V1.1 is delivered on 2 installation disks.
1. Insert the first installation disk.
2. Open the Control Panel Window, choose 'Software' and click on the 'Install' icon.
3. Follow the setup instructions that appear on the screen.
4. The setup routine copies the necessary data and configuration files as well as the chipcard terminal drivers to the hard disk.
5. The Demonstrator icon will be added to the Start Programs menu.
De-installation
In order to de-install the USECA demonstrator application the following tasks have to be performed:
1. Open the Control Panel Window and choose 'Software'.
2. Select Demonstrator and click on the 'Add/Remove Programs' icon.
3. The USECA demonstrator software will be removed from the hard disk after confirming the
security question.
4. Select all chipcard drivers (CHIPDRIVE) and click on the 'Add/Remove Programs' icon.
5. The chipcard terminal drivers will be removed from the hard disk.
USECA/DOC/GD/011/WP27/B