Download Talis Message User Manual
Transcript
Recording a New Prompt If you wish to record a new prompt using your connected microphone: Click the red recording icon on the audio panel. Once you click the icon recording will begin immediately. When the application is recording, the button will have an indented look (see Figure 43). Figure 43 - Client currently recording Once you have finished recording, click on the „Stop‟ button. If you would like to review what has just been recorded, click the „Play‟ button and the audio that was recorded will be played back to you. You can also update the current wording to reflect the changes to the new prompt. This isn‟t a requirement, but it helps to identify the wordings of recordings. You can do this by deleting the existing wording and typing in the words of the new prompt. When you are satisfied with the recording and wording, you can click the „Update‟ button to load the new recording onto the system. If at any stage you wish to cancel the update, click „Cancel‟ and you will be taken back to the main window. When the prompt is loaded, you will be taken back to the main Talis Message Inbound Recording window. Importing New Prompts If you have an existing pre-recorded audio file that you wish to be used, you can import audio from the Update Recording window. Currently Talis Message Inbound Recording will only support the import of .WAV files. Figure 44 - Updating Recording window - Importing To import a .WAV file: Click on the „Update‟ button. Click on the „Import‟ button. This will bring up a box allowing you to find the .WAV file you wish to import. Once you have found the file you wish to use click „Open‟. At this point Talis Message Inbound Recording will attempt to convert the .WAV file into a format suitable for Talis Message. © Talkingtech UD-03-3.0 (Talis Message) 61