Download IPM486 / IPM5 User Manual

,30,30
8VHU0DQXDO
,1752'8&7,21
$%2877+,60$18$/
This Manual assists the installation and initialization procedure by providing all the information necessary to
handle and configure the IPM486 / IPM5.
The manual is written for technical personnel responsible for integrating the IPM486 / IPM5 into their system.
,30,30
All that is written about the IPM486 within this manual can be applied to IPM5 by analogy unless otherwise
noted. Since the IPM5 is shipped without G-96 interface, some parts of the manual are dedicated and valid
for IPM486 only and are gray shaded.
6$)(7<35(&$87,216$1'+$1'/,1*
For personal safety and safe operation of the IPM486, follow all safety procedures described here and in
other sections of the manual.
• Power must be removed from the system before installing (or removing) the IPM486 to prevent the
possibility of personal injury (electrical shock) and/or damage to the product.
• Handle the product carefully, i.e., dropping or mishandling the IPM486 can cause damage to assemblies
and components.
• Do not expose the equipment to moisture.
:$51,1*
There are no user-serviceable components on the IPM486
(/(&75267$7,&',6&+$5*((6'3527(&7,21
Various electrical components within the product are sensitive to static and electrostatic discharge (ESD).
Even a non-sensible static discharge can be sufficient to destroy or degrade a component’s operation!
Following the precautions listed below will avoid ESD-related problems:
• Use a properly installed anti static pad on your work surface.
• Wear wrist straps and observe proper ESD grounding techniques.
• Leave the unit in its anti static cover until you are prepared to install it in the desired environment. When it
is out of its protection cover, place the unit on the properly grounded anti static work surface pad.
• Do not touch any components on the product. Handle the product by its card edges.
(48,30(176$)(7<
Great care is taken by MPL that all its products are thoroughly and rigorously tested before leaving the
factory to ensure that they are fully operational and conform to specification. However, no matter how reliable
a product, there is always the remote possibility that a defect may occur. The occurrence of a defect on this
device may, under certain conditions, cause a defect to occur in adjoining and/or connected equipment. It is
the user’s responsibility to ensure that adequate protection for such equipment is incorporated when
installing this device. MPL accepts no responsibility whatsoever for such kind of defects, however caused.
 1998 by MPL AG
4
MEH-10059-001 Rev. D