Download Atlas Version 1.2 User Guide

Chapter 8: Maps
8.4.4 Set a trial depth
In the depth slider window (see Figure 8-1 on page 94), click and drag the depth
to the new depth.
slider
To access a depth that is not shown on the slider, click zoom out
depth wanted is visible. (You can also zoom in
until the
to decrease the range shown,
and reset the slider to the starting configuration .)
If the slider is not editable, then the initial conditions are set to defaults in the
Hypoinverse Settings.
To make the slider editable, edit the Hypoinverse settings (see Section 5.4.4.5,
“Set initial conditions for Hypoinverse calculations,” on page 67).
Note Hypoinverse allows the setting of a trial depth that applies to all location
runs. The default depth is 7km, but may be reset by editing the Hypo Settings (see Section 5.4.4.5 on page 67). Before locating, the depth can be
reset for the current run.
8.4.5 Fix the current depth
In the Depth slider panel, select the Fix Depth button to fix the depth of the current
run
, and for subsequent Hypoinverse runs.
• If this button is not selectable, the Hypoinverse Settings are set to use default
initial conditions.
• If this button is selected and not editable, then the settings are set to a fixed
depth and all Hypoinverse runs will fix depth (see Section 5.4.4.5, “Set initial
conditions for Hypoinverse calculations,” on page 67).
8.4.6 Create a new solution
See also Section 5.3.1, “Create a new solution,” on page 56.
Toolbar button:
8.4.7 Copy the currently active solution
See also Section 5.3.9, “Copy a solution,” on page 58.
Menu option: Copy Solution
Toolbar button:
8.4.8 Locate the solution
See also Section 5.3.2, “Locate a solution,” on page 56.
Menu option: Locate Solution
Toolbar button:
Version 1.2
104 Atlas
User Guide
14389R5
2005-01-20