Download User Manual - AETA Audio Systems

Ethernet Parameters
This page is for configuring the Ethernet interface and IP addressing, and shows up as follows:
The main setting is the “Mode”: with DHCP, most of the other settings are automatically provided to
the unit by the DHCP server. When there is no such server, you have to enter the settings manually:
select “Manual” for the “Mode”. The IP address must be “available”, i.e. not already assigned to
other equipment. Ask support from the network administrator(s) as needed.
Afterwards, enter the following parameters:
Parameter
Notes
Local IP
Must be unique on the network
Subnet Mask
A typical value is 255.255.255.0
Gateway
DNS Server 1
Domain Name Server (main)
DNS Server 2
Domain Name Server (secondary)
All addresses are in “dot-decimal” format, such as e.g.: 192.168.0.12, 10.0.54.123.
 Note: in contrast to the configuration with DHCP, the “static” setting has to be reviewed each time
you move the unit to a new physical site/network, as the previous IP addressing is probably not
valid for the new location.
42
SCOOP 5 IP - User Manual