Download USER'S MANUAL VC

VC-400RTW+ VDSL2 Slave Modem, Router mit Switch und Access Point, Telekom VDSL2 kompatibel
The screen contains the following details:
Fields in Packet Filtering:
Field
Description
IPV4/IPv6
Choose the appropriate tab to configure.
Enable Packet Filter
To enable the Packet Filter feature of wireless router CPE, select the check box.
Source IP
Filter IP Address range of the local machine under wireless router CPE.
Source Port
Filter Port number range of the local machine under wireless router CPE.
Destination IP
IP address of the destination.
Destination Port
Port address of the destination.
Protocol
Filter protocol. (TCP or UDP).
Ingress Interface
Input interface of the packet.
Egress Interface
Output interface of the packet.
Source MAC Address
Source MAC Address of packet originating host.
Enable
To provide more IP Addresses of the WAN interface.
Add
The screen shown in Figure 4.9.3.1 is displayed when adding a new packet filtering
rule in system.
Delete All
To delete all the packet filtering rules configured in system.


Click Apply at any time during configuration to save the information that you have entered.
Click Cancel to exit from this page without saving the changes.
When you have chosen IPv4 tab, and click Add button in the Packet Filtering page, a screen is displayed as shown in Figure
4.10.3.1. If you choose IPv6 tab and click on Add button, a screen is displayed as shown in Figure 4.10.3.2.
142