Download isadora-v11

• Set the subnet mask to 255.255.255.0
• Click the OK to save your changes and dismiss this window.
• Click OK to save the changes to “Local Area Connection”
• Click “Close” to close the first window.
Serial Output (v1.1)
Isadora can transmit data via standard serial hardware installed on your computer
using the Send Serial Data actor. Before you use this actor, you must configure
Isadora for Serial Output.
Hardware Interface & Drivers
Before you begin, you must have a hardware serial interface that allows you to
connect serial devices to your computer. Before using the interface with Isadora,
you must install its drivers. To do this, please follow the installation instructions in
the interface’s manual. Note: Isadora should not be running when you install the
drivers, otherwise the interface may not be recognized.
After you’ve installed any required drivers, you should connect the install the serial
device or connect it to your computer as appropriate.
Serial Port Setup
Ensure that your serial input/output interface is connected to/installed on your
computer. Then start Isadora and choose Output > Serial Port Setup. A dialog
will appear that looks like this:
Isadora Manual
143