Download User Manual ISO Programming 2500 B
Transcript
Teach-In Tool compensation Position values (coordinates) acquired via “Capture actual position” contain the length and radius of compensation for the tool in use. Therefore it is advisable when programming with “Capture actual position” to enter the correct radius compensation (G41. G42 or G43. G44) and use L = 0 and R = 0 in the tool definition. 1. Tool definition in the part program 3 NlO G95 Tl L+O R+O 2. Tool definition in the central tool file / Tl L+O R+O If the tool breaks or another tool is selected instead of the original, then a different length and radius can be taken into account. The new compensation are differences: Radius compensation R=O values for the tool radius radius compensation for tool radius of the original tool radius of a new tool tool radius of a new tool the tool definition tool 0 0 0 The compensation R can be positive or negative, depending Inserted tool IS larger (+) or smaller (-) than the origrnal tool. The compensation for the new tool length IS also determined (see “Tool definition, Transferring tool length”). The new compensations HEIDENHAIN TNC 25008 R= -__ R = R2-Fi, or R = R3-R, R = RI = R2 = R3 = Length compensation R= +.., are entered in the tool definition Programming Modes on whether the tool radius of the newly as the difference of the original to the originally tool (R = 0, L = 0) Page P 123 used tool