Download Manual

Putting into operation
Manual setting of the IP address
In case no DHCP server is available, the IP address can also be configured manually.
Proceed as follows:
Open a browser (e. g. Internet Explorer) and enter the current IP address of the WLAN
module into the address line. As a result, the configuration page will be opened.
Fig.: Configuration page WLAN module
Setting Serial-Port-Profile
So that the base module of the wireless measurement system works best possible, it
is necessary to configure the Serial-Port-Profile of the WLAN module correctly. For this
purpose, select the point "Serial Port" on the configuration page under "Configuration"
and set the Radio Button to "RealPort".
Fig.: Configuration page Serial-Port-Profile
44