Download ViX IE User Guide

Transcript
136 VIX IE SERVO DRIVE USER GUIDE
C
Continue
Syntax
aC
Description
Properties
Units
-
Default
-
See also
PS
The C (continue) command causes a user command to resume execution
following a pause command.
Immediate only, can’t be used in labelled block, not saved by SV
Example
1PS
1A100
1V20
1G
1”*TEST”
1C
*TEST
CLEAR
;pause commands
;acceleration 100rps2
;velocity 20rps
;go
;add TEST comment
;continue
;message TEST is displayed
Clear user code
Syntax
aCLEAR(label)
Description
Range of ‘n’
-
Units
-
Range of ‘n’
-
Default
-
See also
DECLARE
The CLEAR command deletes user program instructions from the label
specified until the END statement associated with that label. If a subroutine
has been cleared, but its associated GOSUB command still exists, at run
time the code will halt, motion will stop and *E will be reported.
Specifying the ALL keyword as the label will delete all user programs
within the drive addressed.
Properties
Immediate or buffered, can’t be used in labelled block, saved by SV
Example
0CLEAR(ALL)
5CLEAR(START)
Note
You can only clear declarations by using CLEAR(ALL).
; Clear memory of anything defined so far (all drives)
; delete the power on code, but nothing else, in
; axis 5