Download Installation and operating instructions Wolf

5. Installation / Electrical connection of
the programming module
5.1 Wall mounting
For wall mounting, remove the back panel from the programming module.
To do so, carefully lever the l.h. and r.h. side of the programming unit using a
screwdriver and lift off the top part of the back panel.
The back panel can now be secured to the wall with screws through the
fixing holes. (see Fig. A).
Note
5.2 Electrical connection
3063613_201307
A terminal box is required behind the programming module for its
connection (e.g. flush box).
Connection via RJ12 plug
7