Download Netgear Switch L3 User's Manual

7000 Series L3 Managed Switch Reference Manual for Software v2.0
config snmpcommunity mode
This command activates or deactivates an SNMP community. If a community is enabled, an
SNMP manager associated with this community manages the switch according to its access right.
If the community is disabled, no SNMP requests using this community are accepted. In this case
the SNMP manager associated with this community cannot manage the switch until the Status is
changed back to Enable.
Default
Format
The default private and public communities are enabled by
default. The four undefined communities are disabled by default.
config snmpcommunity mode <enable|disable>
<name>
show snmptrap
This command displays SNMP trap receivers. Trap messages are sent across a network to an
SNMP Network Manager. These messages alert the manager to events occurring within the switch
or on the network. Six trap receivers are simultaneously supported.
Format
SNMP Trap Name
IP Address
Status
show snmptrap
The community string of the SNMP trap packet sent to the trap
manager. This may be up to 16 alphanumeric characters. This
string is case sensitive.
The IP address to receive SNMP traps from this device. Enter 4
numbers between 0 and 255 separated by periods.
A pull down menu that indicates the receiver's status(enabled or
disabled) and allows the administrator/user to perform actions on
this user entry:
Enable - send traps to the receiver
Disable - do not send traps to the receiver.
Delete - remove the table entry.
config snmptrap create
This command adds an SNMP trap name. The maximum length of name is 16 case-sensitive
alphanumeric characters.
Default
Format
Switching Commands
The default name for the six undefined community names is
Delete.
config snmptrap create <name> <ipAddr>
7-19