1
Download NEC 2400 PX User's Manual
Transcript
L-3 Line Lockout Interactions (cont’d) 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. CALL WAITING [C-12, 31]: Call Waiting cannot be activated on a station in lock-out. The calling party will receive reorder tone. CALL HOLD [C-6]: From a special dial tone state, LINE lock-out will occur if a user attempting to place a station on hold dials the CALL HOLD [C-6] access code and partially dials any number. The sequence prior to lock-out is: interdigit time-out for 6 seconds, reorder tone for 30 seconds, optional Howler Tone for 30 seconds. When the station in lock-out goes on-hook, it will be rung by the station on hold. The Busy Lamp Field will not flash EXECUTIVE RIGHT-OF-WAY [E-1]: Reorder tone will be returned to a calling party that is attempting Executive Override toward a station in lock-out. THREE-WAY CALLING [T-2]: An attempt to establish a Three-Way Conference with a station in lockout will result in the reorder tone being returned to the user making the attempt. The user can return to the station on hold by switch hook flashing. With the following calls, when a user fails to hang up after the other party has disconnected, the station will be placed in a lock-out condition after a 30-second reorder tone (time-out), optional 30-second Howler Tone warning (time-out): DIRECT INWARD DIALING (DID) call [D-8] STATION-TO-STATION call [S-11] Trunk-to-Station call Attendant-to-Station call CALL BACK [C-1]: To activate Call Back, the user dials the appropriate access code after reaching a busy station. If the user fails to go on-hook within 30 seconds after receiving service set tone, LINE lock-out will occur. The sequence prior to lock-out is: Service set tone for 30 seconds, reorder tone for 30 seconds, optional Howler Tone warning for 30 seconds. Call Back cannot be activated toward a station in lock-out. CALL WAITING - ORIGINATING [C-31]: If a user fails to complete dialing of the access code while attempting to activate CALL WAITING - ORIGINATING [C-31], LINE lock-out will occur. A station in LINE lock-out will be restored to service when the user goes on-hook for 280 milliseconds or more. MESSAGE REMINDER [M-19D]: A Message Reminder cannot be sent to a station in LINE lock-out. ATTENDANT NIGHT TRANSFER [A-19] is not available if the Night Transfer Station is in LINE lockout. The caller will hear ringback tone then reorder tone. Programming ASYD - System Data 1, Index 64, Bits 3 & 4. When is Howler Tone sent? 00: Not sent. 01: Only once. 10: Every thirty seconds. System Data 1, Index 70, Bit 1. Does station in LINE lock-out flash at BLF? 0/1: Yes/No. System Data 1, Index 128. This timer determines how long a register will be held up before the first digit is dialed. Assign 00H for default value of 12 seconds (RAM data is 06H). System Data 1, Index 146. First Howler Tone is sent. Assign 00H for standard default setting of 30 seconds (RAM data is 3FH), on analog ports. Page 424 NEAX2400 IPX Feature Programming Manual NDA-24297, Issue 1
