Download Hunter Engineering Quick Tread Specification Sheet
Transcript
Quick Check Drive Under with Quick Tread Flush Mounted Site Specifications 115/230v, 15 amp* 50/60 Hz 1 phƗ Power Requirements 90-150 PSI (6.2-10.3 bar) Air Supply Req. (IS Units) Approximate Air Consumption 25 SCFM @ 90 PSI (648 Lpm @ 6.2 bar) Substructure Specifications Refer to Form 6905-T Pedestal Location 36 - 96 in. (914 - 2438 mm) from QT1F Product Specifications 3500 lb. (1588 kg) per wheel Max. Wheel Weight 2 to 8 mph (3-13 km/h) Test Entry Speed Shipping Weight Drive Under Quick Check and Flush Mount Quick Tread Installation (shown with optional monitor) * Quick Check Cabinet 290 lbs (132 kg) Quick Check Drive Under Sensor 316 lbs (143 kg) Quick Tread 1723 lbs (455 kg) Amperage shown is minimal circuit rating. Ɨ Isolated ground recommended. OVERALL FOOTPRINT 15 ft. RECOMMENDED BAY WIDTH QUICK TREAD COMMUNICATION CABLES (UP TO 75 ft.) 165 in. (ACCOMMODATES VEHICLES WITH MAXIMUM OF 165 in. WHEELBASE.) 51 in. END OF BAY TO FRONT WHEEL STOP: 120 in. SENSOR HEIGHT: 10 FT. 93 in. (7 ft. 9 in.) 4 in. OPTIONAL PEDESTAL LOCATION RECOMMENDED BAY LENGTH 28 ft. 4 in. Continued on Page 2 For inspection information visit: www.hunter.com/inspection For general inquiries visit: www.hunter.com or call 800 448-6848 For local contact visit: www.hunter.com/company/findrep.cfm Form 6898-T, 05-15a Copyright © 2015, Hunter Engineering Company Quick Check Drive Under with Quick Tread Flush Mounted QUICK CHECK DIMENSIONS 135 in. (11 ft. 3 in.) 15 in. WITHOUT OPTIONAL MONITOR 18 in. WITH OPTIONAL MONITOR 24 1/2 in. SENSOR PROFILE 67 1/4 in. (5 ft. 7 1/4 in.) See 6429-T for support structure details. Mounting plate dimensions are provided to aid fabrication. 16 1/4 in. 16 in. WITHOUT OPTIONAL MONITOR 45 1/4 in. It is recommended that a low clearance warning be suspended at the entrance of Drive Under Quick Check® bays. 22 in. WITH OPTIONAL MONITOR 23 1/2 in. 32 in. QUICK TREAD DIMENSIONS PEDESTAL 26 in. 36 in. 26 in. 5 in. 14 7/8 in. 51 in. 96 in. (8 ft.) is the maximum distance between the middle of the pedestal and nearest edge of Quick Tread. Any further will reduce max vehicle test entry speed. 34 1/2 in. 5 in. 17 3/8 in. 36 to 96 in. (3 ft. to 8 ft.) 93 in. (7 ft. 9 in.) PIT & CONDUIT SPECIFICATIONS END VIEW SIDE VIEW QUICK TREAD: HUNTER SUPPLIED Quick Tread’s 3 in. underground conduit must be routed to the pedestal according to local codes. The pedestal can be placed on either side. Exact placement of conduit will vary. Refer to Form 6905-T. QUICK TREAD SUB-STRUCTURE: CONTRACTOR SUPPLIED 93 in. 51 in. BAY FLOOR 8 in. 12 in. (min.) 46.25 in. 88 in. Form 6898-T, 05-15a Copyright © 2015, Hunter Engineering Company