Download Delta Electronics PG-03 User's Manual

2007-07-14
http://www.deltaww.com
5011619201-G3E1
PG-03 Pulse Generator Card for VFD-B/VFD-V Series
Installation Instruction
Installation
7.5HP (5.5kW) and above
1 to 5HP (0.75kW to 3.7kW)
Exterior of PG-03
Connect to the VFD
Series Control Board
PG-03
G
B
A
FSW2
OC
Select the input
power and the
output type of the
Encoder
TP
B/O
A/O
0V
12V
0V
B
B
A
A
2
Wiring Diagram
R/L1
NFB
R/L1
U/T1
Motor
S/L2
S/L2
V/T2
M
3~
T/L3
T/L3
W/T3
VFD-V
A
A
A
A
PG-03
B
B
B
B
12V
0V
OC
PG
+12V
GND
Shield
Terminal
TP
*Specification of the Encoder
is of the 12V/OC Output
Connection between PG-03 and the Encoder
Connect Externally with the Encoder of 12V Power Supply and Output Signals to Additional
Tachometer
Non-Fuse Breaker
NFB
R/L1
U/T1
S/L2
S/L2
V/T2
T/L3
T/L3
W/T3
R/L1
M
3~
VFD-V
A
A
PG-03
OC
A
A
B
B
B
B
PG
12V
0V
TP
*Specification of the
Encoder is of 12V/OC output,
which could also connect
externally with the RPM wire
GND
A/O
B/O
0V
Shield
Terminal
RPM Meter
*Power of the RPM meter should
be supplied by the customers
Connection between PG-03 and the Encoder
3
PG-03 Terminal Descriptions
Terminals
Terminal Symbols
+12V
0V
Descriptions
Power Supply of the Encoder: +12V
Output Voltage: +12V±5% 200mA
Common point for the power supply and the signal
Encoder signal input (select the output type of the Encoder from FSW2)
Both single-phase input and two-phase input available
Maximum: 500KP/Sec
A/O, B/O
The Encoder signal output
Maximum: DC24V 50mA
Common point for signal grounding
Wiring Notes
1.
Please use a shield cable to prevent interference. Do not run control wire parallel to any high
voltage AC power line (220 V and up).
2.
Connect shielded wire to
3.
Recommended wire size 0.21 to 0.81mm2 (AWG24 to AWG18).
4.
Wire length:
E only.
The Output Types of the Maximum Wire
Encoder
Length
Output Voltage
50m
Open Collector
50m
Line Driver
300m
Complementary
70m
Wire Gauge
1.25mm2 (AWG16) or above
4
The Output Types to Accommodate the Encoder
Output Voltage
Output Types of the Encoder
FSW2 switch
VCC
OC
O/P
TP
0V
Open
Collector
VCC
OC
O/P
TP
Complimentary
Line Driver
0V
Q
OC
Q
TP
VCC
ASIA
DELTA ELECTRONICS, INC.
TAOYUAN Plant/
31-1, SHIEN PAN ROAD,
KUEI SAN INDUSTRIAL ZONE
TAOYUAN 333, TAIWAN
TEL: 886-3-362-6301
FAX: 886-3-362-7267
OC
O/P
TP
0V
NORTH/SOUTH AMERICA
DELTA PRODUCTS
CORPORATION
Sales Office/
P.O. BOX 12173
5101 DAVIS DRIVE
RTP, NC 27709 U. S. A.
TEL: 1-919-767-3813
FAX: 1-919-767-3969
EUROPE
DELTRONICS (Netherlands) B.V.
Sales Office/
Industriegebied Venlo Nr. 9031
Columbusweg 20
NL-5928 LC Venlo
The Netherlands
TEL: 31-77-324-1930
FAX: 31-77-324-1931