Download Avaya BCM Management User Guide

118
Chapter 2 Fault Management System
emsManager
emsManager
Return to table:
Return to table:
Service:
Message:
User action:
Alarm severity:
Trap-type:
Logs:
Component ID (alarm)/eventSource (trap) summary
Component ID alarms/eventSource (Trap) by event ID
Media services manager
Service started.
No action required.
Warning
Information
None
Event ID: 1001
Message:
User action:
Alarm severity:
Trap-type:
Logs:
Service terminated.
No action required.
Warning
Information
None
Event ID: 3000
Message: MSC Driver is in the core upload mode - aborting.
User action: If this happens due to an interrupted upload of the core image, the
user must upload the core. Once the upload procedure completes
successfully, the error will go away. If this happens during a core
upload, no action is required (it should not happen, because during the
core upload, there is no reason to start the MSM).
Alarm severity: Critical
Trap-type: Error
Logs: None
Event ID: 3001
Message: Registry contains an invalid published IP address.
User action: This happens only if the IP address of a NIC, that is currently selected
in the Published IP Address field of the UM, has been changed and
due to some kind of an error the registry was not properly updated.
Use the Unified Manager to select the Published IP Address again.
Recommended method is to change it to another NIC and then back to
the desired NIC.
Alarm severity: Critical
Trap-type: Error
Logs: None
Event ID: 3002
Message:
User action:
Alarm severity:
Trap-type:
Logs:
Event ID: 1000
P0609330 2.0
BCM switch reset - disconnecting all applications
No action required.
Critical
Error
None