Download LPOD-R manual - Comtech EF Data
Transcript
LPOD-R Outdoor Amplifier / Block Up Converter (BUC) Optional Serial-based Remote Product Management Parameter Type IP Address Command (Instruction Code and Qualifier) IPA= Arguments for Command or Response to Query 18 bytes MN-LPODR Revision 1 Description of Arguments (Note that all arguments are printable ASCII characters) Command or Query. Used to set the IP address and network prefix for the 10/100 BaseT Ethernet port, in the form xxx.xxx.xxx.xxx.yy, where: xxx.xxx.xxx.xxx = IP address yy = network prefix (8-30) Response to Command (Target to Controller) IPA= IPA? IPA* IPA# Query (Instruction Code and Qualifier) IPA? Response to Query (Target to Controller) IPA= xx.xxx.xxx.xxx.y y (See description of arguments) IPG= IPG? IPG* IPG? IPG = xxx.xxx.xxx.xxx ISP= ISP? ISP* N/A N/A LNA= LNA? LNA=YY..ss Default Value: 192.168.001.004.24 Example: <1/IPG=192.168.001.004.24’cr’ >0001/IPG=’cr’’lf’ Gateway Address IPG= 15 bytes Note: Changing the IP address through the Telnet interface requires that you power cycle the unit, and then restart a new Telnet session with the new IP address (do not include the network prefix, e.g., type in 192.168.1.4 only) Command or Query. Sets or returns the Gateway IP address for the 10/100 Base Tx Ethernet port, in the form xxx.xxx.xxx.xxx. Default Value: 192.168.001.005 Initialize Statistics Pointer ISP= Retrieve next 5 unread Stored Alarms E N/A None 145 bytes Example: <1/IPG=192.168.001.005’cr’ >0001/IPG=’cr’’lf’ Command only. Resets the internal pointer to allow RNS? queries to start at the beginning of the stored statistics log. Example: <1/ISP=’cr’ >0001/ISP=’cr’’lf’ Query only. Returns the five oldest stored events in the alarm log in the form: YYYYYYYYYY ZZ mmddyy hhmmss’cr’ YYYYYYYYYY ZZ mmddyy hhmmss’cr’ YYYYYYYYYY ZZ mmddyy hhmmss’cr’ YYYYYYYYYY ZZ mmddyy hhmmss’cr’ YYYYYYYYYY ZZ mmddyy hhmmss’cr’’lf’ Where: YYYYYYYYYY = fault description. ZZ = one of the following event types: FT = Fault OK = Clear IF = Information mmddyy hhmmss = date / time stamp. 5–15 (See Description of Arguments for details)