1
Download Intermec EasyCoder 4420e Thermal Label Printer
Transcript
Chapter 1— Getting Started C d 39 Helvetica CondensedHelvetica ➤ ➤ 1 2 3 4 5 6 7 8 ➤ ➤ 1 2 3 4 5 6 7 8 ➤ Media access slot Head lift lever Edge guide Lower media guide Supply roll post I O Fanfold media Supply roll retainer 44XXU008.eps 4 Place the fanfold media slightly lower than the slot in the printer back cover. Align the fanfold media with the label path through the printer. Insert media through the slot at the rear of the printer and thread it over the supply roll post. 5 Unscrew the edge guide and slide it to the outer edge of the lower media guide. Screw it in place. 6 Pull down on the lower media guide to allow easy access to the media path. 7 Insert the fanfold media through the printer mechanism as shown in the previous illustration. The fanfold media passes over the supply roll post and out the front opening of the printer. 8 Release the lower media guide and adjust the edge guide to position the media firmly against the inside wall of the printer. 9 Slide the supply roll retainer up to the edge of the fanfold media and turn the supply roll retainer clockwise until it locks firmly in place. This action secures the media against the inside wall of the printer. 10 Rotate the head lift lever counterclockwise until it locks to engage the printhead. 10 EasyCoder 4420 and 4440 Bar Code Label Printer User’s Manual
