Download Lucent (TNT-SL-S50) Expansion Module

Transcript
Configuring Frame Relay Direct
Examples of Frame Relay direct connections
Figure 5-1. Frame Relay direct
Caller-1
2.2.2.2/32
frswitch-1
1.1.1.1
TAOS
DLCI 100
Caller-2
3.3.3.3/32
The following commands specify a PVC to frswitch-1:
admin> new conn frswitch-1
CONNECTION/frswitch-1 read
admin> set active = yes
admin> set encapsulation-protocol = frame-relay
admin> set ip-options remote-address = 1.1.1.1/24
admin> set telco-options call-type = ft1
admin> set fr-options frame-relay-profile = ct1-1.7.5
admin> set fr-options circuit-type = pvc
admin> set fr-options dlci = 100
admin> write
CONNECTION/frswitch-1 written
Following is a comparable RADIUS profile:
permconn-sys-2 Password = "ascend", User-Service = Dialout-Framed-User
User-Name = "frswitch-1",
Framed-Protocol = FR,
Framed-Address = 1.1.1.1,
Framed-Netmask = 255.255.255.0,
Ascend-FR-DLCI = 100,
Ascend-FR-Profile-Name = "ct1-1.7.5"
The following set of commands configures Frame Relay direct Connection profiles:
admin> new conn caller-1
CONNECTION/caller-1 read
admin> set active = yes
admin> set encapsulation-protocol = ppp
admin> set ppp-options recv-password = caller1*3
admin> set ip-options remote-address = 2.2.2.2/32
admin> set fr-options fr-direct-enabled = yes
admin> set fr-options fr-direct-profile = ct1-1.7.5
admin> set fr-options fr-direct-dlci = 100
admin> write
CONNECTION/caller-1 written
APX 8000/MAX TNT/DSLTNT Frame Relay Configuration Guide
5-3