Download Lucent (TNT-SL-S50) Expansion Module
Transcript
Configuring Frame Relay Direct Examples of Frame Relay direct connections Figure 5-1. Frame Relay direct Caller-1 2.2.2.2/32 frswitch-1 1.1.1.1 TAOS DLCI 100 Caller-2 3.3.3.3/32 The following commands specify a PVC to frswitch-1: admin> new conn frswitch-1 CONNECTION/frswitch-1 read admin> set active = yes admin> set encapsulation-protocol = frame-relay admin> set ip-options remote-address = 1.1.1.1/24 admin> set telco-options call-type = ft1 admin> set fr-options frame-relay-profile = ct1-1.7.5 admin> set fr-options circuit-type = pvc admin> set fr-options dlci = 100 admin> write CONNECTION/frswitch-1 written Following is a comparable RADIUS profile: permconn-sys-2 Password = "ascend", User-Service = Dialout-Framed-User User-Name = "frswitch-1", Framed-Protocol = FR, Framed-Address = 1.1.1.1, Framed-Netmask = 255.255.255.0, Ascend-FR-DLCI = 100, Ascend-FR-Profile-Name = "ct1-1.7.5" The following set of commands configures Frame Relay direct Connection profiles: admin> new conn caller-1 CONNECTION/caller-1 read admin> set active = yes admin> set encapsulation-protocol = ppp admin> set ppp-options recv-password = caller1*3 admin> set ip-options remote-address = 2.2.2.2/32 admin> set fr-options fr-direct-enabled = yes admin> set fr-options fr-direct-profile = ct1-1.7.5 admin> set fr-options fr-direct-dlci = 100 admin> write CONNECTION/caller-1 written APX 8000/MAX TNT/DSLTNT Frame Relay Configuration Guide 5-3