Download Kodak DCS 460 Digital Camera User Manual

Extension
function
code
Contents and display
Adjust reduced voltage start.
FUNC
Initial value
➤
➤
2
: There is no reduced voltage. The rush
current at the start of the inverter is
increased but the motor reaction time is
decreased.
¥
¥
¥
¥
➤
Reduced
voltage
soft start
setting
NOTE: How to set
FUNC
1
➤
: The effect of the reduced voltage is
large.
The rush current is reduced but the
motor reaction time is increased.
Select the running mode. Set the running mode to be used.
Set value
Setting method
➤
2
Running
mode
selection
FUNC
➤
FUNC
Initial value
1
➤
➤
0
Function
Normal running mode
1
Energy conservation running mode
2
Fuzzy most suitable acceleration
and deceleration mode
Initial value
NOTE:
When the fuzzy most suitable acceleration and deceleration are selected and the load inertia (motor shaft
conversion) is more than about 20 times of that of the individual motor, an overvoltage trip may occur.
If this occurs, reset the mode to the normal running mode. For other precautions, refer to "Precautions for
fuzzy most suitable acceleration and deceleration" of Appendix 1.
Set the running command so as to be inputted to the terminal.
(Set
to
or
.)
➤
2
1
➤
FUNC
➤
.
FUNC
(REV) (JG)
➤
CM1
FW
8
3
Initial value
➤
2
1
➤
,
,
,
.
NOTE:
No frequency can be set
between 0.01 Hz and 0.09 Hz.
SWFW
SWJG
Operation timing
SWJG
20 msec min
➤
➤
SWFW
Motor
rotation
Free run
➤
Jogging
frequency
setting
Since jogging is a direct input operation and may be easily tripped, set the jogging frequency
to 5 Hz or less.
.
Setting method
The free run operation is performed immediately after
SWFW is turned OFF.
No jogging operation is performed when the set value is smaller than the start frequency
7-24
.