Download Kodak DCS 460 Digital Camera User Manual

12.3
Function mode
Function mode list when the remote operator is used
• Function mode initial values and display contents
Initial display contents, initialization, and change ranges are displayed in the table
indicated below.
(Function mode 1)
Display
Function
Function
sequence
No.
name
1
F-00
Base
frequency
setting
2
F-01
Maximum
frequency
setting
3
F-02
Start
frequency
adjustment
4
F-03
Motor input
Input
voltage
voltage setting
AVR
function
for
deceleration
5
F-04
Control
method
setting
6
F-05
(Function mode 2)
Initialization display
contents
F-BASE
0060 Hz
Initialization
Setting, change
contents
60 Hz
30 to 120 (400)
F-MAX
0060 Hz
60 Hz
30 to 120 (400)
Fmin
0.50 Hz
0.5 Hz
0.1 to 9.9
AVR AC
460 V
AVRDEC
CONTROL
230/460
200,215,220,230
/380,400,415
440,460,480
ON/OFF
OFF
OFF
VC
VC
VC, VP1, VP2,
VP3, SLV, V2
Autotuning
Motor
AUX AUTO
setting
NOR
NOR
NOR/AUT/NRT
Motor data
selection
AUX DATA
NOR
NOR
Motor
capacity
AUX K
005.50 kW
NOR: Old Hitachi
general purpose
TMO: New
Hitachi general
purpose
AUT: Autotuning data
3.7 to 160
setting
AUX P
4p
constant
(NOTE 1)
Motor pole
count
setting
Motor
constant
R1 setting
Motor
constant
R2 setting
Motor
constant
L setting
Ratedcapacity
ofeachinverter
4p
2, 4, 6, 8
AUX R1
1.004
Ratedcapacity
ofeachinverter
0 to 65.535
AUX R2
0.776
Ratedcapacity
ofeachinverter
0 to 65.535
13.16 mH
Ratedcapacity
ofeachinverter
0 to 655.35
AUX L
NOTE 1: The motor constants R1, R2, L, M, J, Kp, Ti, and KPP vary with the capacity.
12-5
Setting contents
• When 120 Hz is switched to
400 Hz by F-30, a frequency
more than 120 Hz can be set.
• The equipment starts running
at this set value.
• The motor input voltage is set.
• ON or OFF of the AVR
function for deceleration
is set. When dynamic
braking torque is necessary
for deceleration, OFF is set.
• VC, VP1, VP2, VP3:
V/F characteristics
SLV:Sensorless vector control
V2:Sensor vector control
• At the first running after
AUT/NRT is set, the
autotuning measurement
operation is executed.
• The autotuning motor data
before starting autotuning
measurement is data
equivalent to NOR.
• Set a capacity smaller than the
rated capacity as capacity
data.
• The number of poles of the
motor to be used is set.