Download Aristel DV Phone System Programming

Transcript
Note! Zone 119 must be a value greater than 015 if Zone 229 = 4 or 5
Related Zones. Z122, Z119,
Zone 230
Link Monitor
Default value = 0
Range = (0 ~ 1)
VSU
FITTED
ZONE 229 =
1
TIME =
Z119 x 1
10 SEC. =
BOTH
PARTIES
HEAR BEEP
VSU
FITTED
ZONE 229 =
4
TIME =
Z119 x 10
10 SEC. =
ONLY B
PARTY
HEARS
BEEP
VSU
FITTED
ZONE 229 =
5
TIME =
Z119 x 10
10 SEC. =
BOTH
PARTIES
HEAR BEEP
NO VSU
ZONE 229 =
1
TIME =
Z119 x 1
10 SEC. =
BOTH
PARTIES
HEAR BEEP
10 SEC. =
BOTH
PARTIES
HEAR BEEP
5 SEC. =
BOTH
PARTIES
HEAR
MESSAGE
CODE 07
5 SEC. =
BOTH
PARTIES
HEAR
MESSAGE
CODE 07
5 SEC. BOTH
PARTIES
HEAR
MESSAGE
CODE 07
CALL IS
DISCONNECTED
CALL IS
DISCONNECTED
CALL IS
DISCONNECTED
5 SEC. =
CALL IS
BOTH
DISCONNECTED
PARTIES
HEAR BEEP
NO VSU
ZONE 229 =
TIME =
10 SEC. =
CALL IS
Z119 x 10
4
ONLY B
DISCONNECTED
PARTY
HEARS
BEEP
10 SEC. =
10 SEC. =
CALL IS
NO VSU
ZONE 229 =
TIME =
Z119 x 10
BOTH
BOTH
DISCONNECTED
5
PARTIES
PARTIES
HEAR BEEP HEAR BEEP
This Zone allows the system to maintain the cross-links connections after an abnormal disconnect.
0 = Disable
1 = Enable
Related Zones. None
Zone 231
Volume Initi VAL.
Default value = 3
Range = (1 ~ 8)
Start-up volume level for Speaker, Ringing and Handset tones for Keyphones. 8 initial levels can be set.
NOTE! System must be powered down/up for change in data to be affected
Related Zones. None
Zone 232
B.B.C. Pause TIMES
Default value = 01
Range = (00 ~ 99)
This Zone sets the number of pauses in Speed Dial (only Speed Dial). The value set in Zone 100 is multiplied
by the value in this zone. E.g.: If the value in Zone 100 = 20, then pause time of 20*40=800 Ms. If this zone =
2, the pause time for Speed Dialing will be 1600 Ms.
Revised by R. Robinson
Issue DV2.3 21 November 2006
24