Download Aristel DV Phone System Programming

Transcript
Only 1st port prog. + SLT ring = intercom cadence
Any ext can prog. + SLT ring = incoming cadence
Only 1st port prog. + SLT ring = incoming cadence
Z235=3
Z235=4
Z235=5
Related Zones. Z300 Item 1
Zone 236
Dial Tn Tms
This Zone has no function in Australia.
Related Zones. None
Zone 237
Slt Pulse #*
Default value = 0
Range = (0:D ~ 1:E)
This Zone allows or Disallows a decadic (Pulse) SLT to simulate the # and * keys.
0 = Disable. Pulse dialing SLTs cannot use the # and * functions. In this mode of operation, station numbers
may start with 7 and 8.
1 = Enable. Pulse SLTs can simulate the # with digit 7 and the * with digit 8. In this mode of operation station
numbers should not start with 7 and 8.
Note! This zone will disable 81/82 Message Waiting signals.
Related Zones. Z245
Zone 238
DISA Group
Default value = 0
Range = (0:D ~ 1:E)
This Zone allows or disallows single digit groups on an incoming DISA line.
NOTE! This is not One Digit Dialing as in zone 401, but allows access to the groups set up in zone 607.
0= disable
1=enable
2~4=dept working
Dept. working allows full digit working with 8 being the “breakout” digit to go to 1 of the 8 departments as in
zone 607 Groups 1~8
DEPARTMENT WORKING FOR DISA
8 Departments can be created in zone 607. These departments can be accessed via the Auto-Attendant by
dialing 8 and the Dept number during/after the greeting message. The number of depts. Depends on the setting
in zone 238 as shown below:Zone 238 = 0
No Group or Department working available
Zone 238 = 1
Groups 1, 2, 3, 4, 5, 7, 8 are available in zone 607. To call a particular extension, the caller dials 6 followed by
the extension number. Hence, no group 6 is allowed. To call a group, the caller dials the group number and all
ext in the group will ring.
Zone 238 = 2
Groups 1, 2, 3, 4, 5, 6, 7, 8 are available in zone 607. To call an extension, the caller dials the extension
number (must not begin with 8). To dial a department, the caller dials 8 and hears the Dept Greeting message.
The caller can then dial 1~8 to get to the desired dept. All exts in the group will ring.
Zone 238 = 3
Groups 6, 7, 8 are available in zone 607. To call an extension, the caller dials the extension number (must not
begin with 8). To dial a department, the caller dials 8 and hears the Dept Greeting message. The caller can then
dial 6~8 to get to the desired dept. All exts in the group will ring. This allows extensions to begin with 1~5
Zone 238 = 4
This is the same as zone 238 = 2 but it also has the added feature:-
Revised by R. Robinson
Issue DV2.3 21 November 2006
26