Download Aristel AV Phone System Programming

Transcript
Range = (0 ~ 2)
This Zone can override the restriction applied by Zone 603 for CO access by the Station.
0 = Disable Zone603 restriction.
1 = Outgoing calls, by pressing DSS CO keys, are restricted to the access assigned in Zone 603.
2 = The station can answer or pickup the incoming line according to Zone 503 Item 4 and Zone 608.
Related Zones. Z503 Item 4, Z603, Z608
Zone 223
Auto-Redial TIMES
Default value = 20
Range = (00 ~ 99)
This Zone sets the number of attempts that Auto-redial will use.
Related Zones. Z120, Z121
Zone 224
Limit Call CODE
Default value = 2
Range = (0 ~ 8)
This Zone determines the warning method used by the system when call limiting is applied in Zone 507 Item
02.
0 = A 1 second warning beep is followed 5 seconds later by five 1 second beeps when the time set in Zone 507
Item 02 is reached and the call continues.
1 = A 1 second warning tone is followed 5 seconds later by 5 seconds of beeps. This is repeated every time the
setting in Zone 507 Item 02 has expired and the call continues.
2 = At 10 seconds before the setting in Zone 507 Item 02, a warning tone will be heard. This is followed by a
continuous beeping 5 seconds later (this will be heard only by the internal party unless it is an SLT, in
which case both parties will hear the tone). When the Zone 507 Item 02 time has expired, the call will be
released.
3 = This is the same as in 2. With the exception that both parties will hear the tone.
4 = Reserved
5 = Same as in 0, but applies for incoming as well as outgoing.
6 = Same as in 1, but applies for incoming as well as outgoing.
7 = Same as in 2, but applies for incoming as well as outgoing.
8 = Same as in 3, but applies for incoming as well as outgoing.
9 = Reserved.
Related Zones. Z507 Item 2
Zone 225
Speed Dial
Default value = 0
Range = (0 ~ 9)
This Zone allocates the amount of system and individual speed dial numbers as set out in the table below:
WHEN ZONE 227 (NAME SPEED DIAL) IS DISABLED. Ie.: ZONE 227 = 0
AV8, AV12, AV16, AV20, AV24, AV38
ZONE
SYSTEM
INDIVIDUAL
SETTING
SPEED DIAL
SPEED DIAL
VALUE
SETS
SETS
0
100 (100~199)
580
1
200 (100~299)
480
2
300 (100~399)
380
3
400 (100~499)
280
4
500 (100~599)
180
5
600 (100~699)
80
6,7,8,9
SAME AS 5
SAME AS 5
NOTES:
IF LCR IS ENABLED IN ZONE 253, THIS ZONE MUST BE GREATER THAN 0 OR
ONLY THE FIRST 50 SPEED DIAL CODES WILL BE AVAILABLE.
Revised by R. Robinson
Issue AV1.13 8 June 2006
22