Download Aristel AV Phone System Programming

Zone 235
System PSW
Default value = 0
Range = (0 ~ 1)
This Zone sets the programming ability to the station in the 1st port only.
Related Zones. Z300 Item 1
Zone 236
Dial Tn Tms
Default value = 06
Range = (00 ~ 99)
This Zone has no function in Australia.
Related Zones. None
Zone 237
Slt Pulse #*
Default value = 0
Range = (0:D ~ 1:E)
This Zone allows or Disallows a decadic (Pulse) SLT to simulate the # and * keys.
0 = Disable. Pulse dialing SLTs cannot use the # and * functions. In this mode of operation, station numbers
may start with 7 and 8.
1 = Enable. Pulse SLTs can simulate the # with digit 7 and the * with digit 8. In this mode of operation station
numbers should not start with 7 and 8.
Note! This zone will disable 81/82 Message Waiting signals.
Related Zones. Z245
Zone 238
DISA Group
Default value = 0
Range = (0:D ~ 1:E)
This Zone allows or disallows single digit groups on an incoming DISA line.
NOTE! This is not One Digit Dialing as in Zone 401, but allows access to the groups set up in Zone 607.
Related Zones. Z607
Zone 239
DND Disable
Default value = 0
Range = (0:D ~ 1:E)
This Zone allows or disallows Do Not Disturb on a system wide basis and can over-ride the DND button.
0 = Disable. The system does have the Do Not Disturb function available.
1 = Enable. The system does not have the Do Not Disturb function available.
Related Zones. None
Zone 240
Auto Co Dis.
Default value = 0
Range = 00 ~ 11 (0:D ~ 1:E)
This Zone allows or disallows the automatic access to a C.O. line by lifting the handset. The function can be
individually toggled by:- SPK, #, 5, 0. (NOTE! Disable means will work & enable means will not work)
This zone will be over-ridden by Zone 508. 0=enabled: 1=disabled.
\Hot Line Ability.
This allows or disallows the extension to access a CO line by lifting the handset. This feature can be toggled by
the extension pressing SPK, #, 5, 0
Relay Active Time.
This will keep the relay operated for 8 seconds in lieu of the default 2 seconds. Relays are set in Zone 302
Door Ringing
This allows a Door (1 or 2) to ring its own group only, or to ring both groups as programmed in Zone 602.
Revised by R. Robinson
Issue AV1.13 8 June 2006
27