Download Sharp AR-M455 Operation Specifications

CHECKING THE SIZE OF A PLACED
ORIGINAL
If the placed original is a standard size, the size will be automatically
detected (automatic original detection function) and displayed in the touch
panel. Make sure that the correct size has been detected.
(A) :The original size is displayed.
(B) :[AUTO] appears when the automatic original detection function is
operating.
If you have loaded a non-standard size original or wish to change the
scanning size, you can follow the steps below to manually set the original
scanning size. (For the standard sizes, see "Original size detection
function" on page 4-3.)
0
81/2x11
AUTO
ORIGINAL
AUTO
EXPOSURE
(A)
(B)
NOTE
If a non-standard size original is loaded (including special sizes), the closest standard size may be displayed,
or the original size may not appear at all.
If "CANCEL DETECTION AT DOCUMENT GLASS" is enabled in the key operator programs (see page 11 of
the key operator’s guide), automatic original detection at the document glass will not operate. In this case,
follow the steps below to manually set the original scanning size.
Manually setting the scanning size
If you load an original that is not a standard size (such as an AB size), or if the size is not detected correctly, you must
touch the [ORIGINAL] key and set the original size manually. Perform the following steps after placing the document
in the automatic document feeder or on the document glass.
1
If a non-standard size original is placed in
the document feeder or on the document
glass, touch the [SIZE INPUT] tab and then
enter the X (width) and Y (length)
dimensions of the original.
Touch the [ORIGINAL] key.
0
AUTO
ORIGINAL
X is initially selected.
Enter the X dimension
1/2 17)
(width) and then touch
X
17 (2
inch
the Y( ) key and enter
1/2 11 5/8)
Y
11 5/8 (2
inch
the Y dimension (length).
STANDARD SIZE
SIZE INPUT
X can be from 2-1/2 to 17
inch, and Y can be from
2-1/2 to 11-5/8 inch.
If you frequently use originals that are the same
non-standard size, you can store the size as
explained in "STORING, DELETING, AND USING
ORIGINAL SIZES" on the following page. This will
save you the trouble of manually entering the size
each time you use that original size.
X
OK
Y
AUTO
EXPOSURE
2 Touch the desired original size key.
51/2X81/2
81/2 X13
[AUTO] is no longer
highlighted. [MANUAL]
and the original size key
you
touched
are
highlighted.
OK
51/2X81/2R
81/2 X14
AB
81/2X11
11X17
INCH
81/2X11R
STANDARD SIZE
SIZE INPUT
If you wish to select an AB size, touch the
[AB/INCH] key and then touch the desired
original size key.
A5
A4
OK
A5R
A4R
AB
B5
B4
INCH
B5R
A3
STANDARD SIZE
SIZE INPUT
[AB] is highlighted and
AB size keys are
displayed. To return to
the inch palette, touch
the [AB/INCH] key once
again.
3 Touch the [OK] key.
You will return to the initial screen.
selected original size appears in the
4 The
top half of the [ORIGINAL] key.
0
A4
ORIGINAL
AUTO
EXPOSURE
4-5
4