Download AOR AR8200 Specifications
Transcript
Section 3-8, 3-9, 3-9-1 The display doesn’t correct immediately upon frequency entry to allow you to enter the ‘STEP-ADJUST’ menu to change the step size and step-adjust in order to help track unusual band plans. &Note: AUTO-STEP, STEP-ADJUST and AUTO-MODE are linked to the pre-programmed bandplan data. When one of the parameters is changed from the default “AUTO” the bandplan will be ignored. To re-instate AUTO step size, the receive MODE must be returned to “AUTO” using the “MODE SET” menu or by using the key sequence 3-9 STEP-adjust The AR8200 provides a powerful feature to enable accurate following of unusual band plans. When active, the “ADJ” legend is displayed top-centre of the LCD. Step-adjust is used when the receiving frequency is not divisible by the step size in use (It is possible that step-adjust has been programmed into the auto-mode bandplan data for some world market areas). Therefore step-adjust is useful for certain band plans such as cellular which in some areas starts as 917.0125 MHz then increments in 25 kHz steps. Another example is the CB allocation in certain areas which starts at 27.60125 MHz then increments in 10 kHz steps. Often just a HALF STEP is required but more exotic band plans can be tracked. Step-adjust may be factory pre-programmed into the bandplan data (you may over-ride this). It is also possible to store the step-adjust data into memory channels and search banks. 3-9-1 Automatic calculation of step adjust The AR8200 can calculate the required step-adjust, simplifying its use. Example 1: Assume that you wish to tune from 148.010 MHz in 20 kHz steps (i.e. 148.010, 148.030, 148,050, 148.070, 148.090 etc). When manually tuning, the AR8200 would normally correct the frequency display to read 148.020 then step upward in 20 kHz steps. Tuning back downward will skip 148.010 MHz (the starting point) as the original frequency was not divisible by step size… it was offset by +10 kHz. Usually the frequency must be divisible by the tuning step size. However, the STEP-ADJUST facility is used to address this situation. With the above example of 148.010 MHz with 20 kHz steps in mind, while in VFO mode, key in the start frequency of 148.010 MHz 33