Download Micom 3T Operating instructions

Transcript
Using the Vocoder
➤
To use the vocoder in the Channel mode:
MICOM-3
1.
Press the F1 key whenever it is necessary to toggle between the
PVT (Private), DIG, and CLR (Clear) modes.
CLR
CH 6
F 16,000.00 BAND
I
BW3.3K
USB
SQ
DSP
MICOM-3
PVT3
CH 6
F 16,000.00 BAND
I
BW3.3K
Note
When using the digital mode, you see DIG (F1) instead
of PVT#.
USB
DSP
MICOM-3
DIG
CH 6
F 16,000.00 BAND
I
BW3.3K
➤
USB
DSP
To use the vocoder in the Frequency mode:
MICOM-3
1.
2.
➤
When using the Frequency mode, press MORE twice to access
the third screen.
RCLV
FREQ
F 16,000.00 STOR
I
BW3.3K
USB
CLR
Press the F3 key whenever it is necessary to toggle between the PVT (Private), DIG, and
CLR (Clear) modes.
To use the vocoder in the ALE mode:
1.
Enable the ALE mode, as described in Enabling the ALE Mode on page 43.
2.
When using the DIG mode, the radio scans automatically in the CLR mode (you may see
that the bandwidth returns to the default, 2.7K) and switches to the DIG mode without
your intervention when a DIG call is detected.
When using the PVT mode, you must press the F1 key to switch to the CLR (Clear) mode
to enable the radio to scan or to initiate a call to the desired destination. After a link is
established, press CLR (F1) to switch to the PVT mode. Switch back to the CLR mode after
the link is disconnected.
101