Download Installation Instructions

Installation
Options
Slainless
Sled
Gas
( ool:top
Cooktop
Installation
with a 36" Monogram
Downdraft
Vent, models ZVB36.
Tile installation
of tile downdrafl
vent with
Countertop
Requirements:
Tile cotmtertop
must have a deep
this cooktop
requires
carefid consideration.
Both tile cooktop
and tile vent must be
installed according
to each specific installa-
Countertoi)s
with a rolled front edge and
backsplash
will not provide tile fiat surthce
area required.
• Review tile illustration
to determine
tile
to
tion instruction.
For accurate
planning,
review the Downdrafl
Vent Installation
Inst_ uctions
49-80185.
in adwmce,
order
Pub.
tile
accOillii/o(late
cooktop
and
fiat surface
vent.
cotmtertop
sm'thce requirements.
-All cutout clearances
tot this installation
nlust be observed.
No.
TopView-CountertopSurface
9/16"
2-9/16"
21-7/16"
Cutout
Depth
36-1/2'_
34" VentCutout
9/16
Overlap
'
;_
'
i
18-7/8"
Cooktop
Cutout
Depth
_Front
35-5/16"
CooktopArea Cutout
Edge of Countertop
Base Cabinet Requirements:
Tile combined
installation
will fit in a stan-
dard 24" deep base cabinet. A base cabinet
least 42" wide is recommended.
-Tile vent housing,
blower
occupy the base cabinet.
and ductwork
at
will
Ductwork:
Ductwork
should be planned
in adwmce.
• The blower system is designed
for use with
3-1/4" x 10" ductwork.
It can be transitioned
6"
22-3/4"
Total Flat
Surface
Required
at Center
7/16" CooktopOverlap
(1-1/4" at Center)
2-3/4" Min. Clearance to Cutout
to
Cutoutto
RearVertical
Combustible
Surface
I'Otlnd.
-The ductwork
MUST be vented to the
outside.
-The duct mn should not exceed 150 It. or
equiwdent
length when bends or wu'ious
fittings are used.
Again, refer to Downdraft
Vent Installation
Instructions
for details.
11-9/16" Min. Cutout
to Wall, Both Sides
Power Supply:
If local ('odes permit,
tile vent and cooktop
may operate
from tile same 120V, 15 amp
dui)lex outlet, i,ocate tile gas and electrical
suI)ply as shown on page 6.