Download Embedded LPC3250 User`s guide

Transcript
LPC3250 Developer’s Kit v2 - User’s Guide
Page 19
When working with the LPC3250 OEM Board, J7 is typically used. If an older and big footprint
JTAG debug pod is used, J8 can alternatively be used.
JP3, J9 and J10 are not used when working with LPC3250 OEM boards.
JP4 shall be open (no jumper inserted) for enabling the JTAG interface of the LPC3250 OEM board.
Also note that the LPC3250 has a JTAG interface. Not the newer SWD interface.
ETM Control Jumpers
JP3
Debug Connectors
J8
Debug Control Jumpers
JP4
Trace&Debug
Connectors
J10
Trace&Debug Connectors
J9
Debug
Connectors
J7
Reset LED
LED17
Figure 5 – Debug Interfaces
Copyright 2012 © Embedded Artists AB