Download Multitech MMH900 User guide

Transcript
Appendix J - Internal MMH2834 Composite Link Modem Commands
J.1.5 Command Response (Result Code)
Commands
Echo Command
Mode Characters
E
If the MMH2834 is connected to a full-duplex computer, it may
be necessary for the modem to be configured to echo back
characters entered while in the command mode in order for them
to be displayed. The E command is used to configure the
Command Mode echo, with ATE0 disabling the echo and ATE1
enabling the echo (default).
Result Codes
Enable/Disable
and No Response
Answer
Q
The Q command enables or disables Result Codes and the No
Response Answer mode of operation. Result Codes may be
disabled altogether in certain applications, such as computercontrolled auto dialing, using the Q command. ATQ1 disables
Result Code transmissions. ATQ0 (or ATQ) enables Result
Code transmission.
Regarding No Response Answer, you may want the answer
mode handled without responses and echo turned off, but want
the originate mode still intelligent. This is called the No Response
Answer mode. ATQ2 selects the No Response Answer mode. If
you do not select any mode, the factory default setting (enable
Result Codes) is automatically selected.
Result Codes
(“Multi-Tech” or
“Standard AT”)
&Q
The MMH2834 gives you a choice between the Multi-Tech
Result Codes, and Result Codes that more closely match the
standard AT command set responses. AT&Q1 selects AT
responses with no Reliable/Compression modifiers. With this
command, the terse result code for CONNECT 2400 is 10.
TERSE
0
1
2
3
4
5
6
7
8
10
11
VERBOSE
OK
CONNECT
RING
NO CARRIER
ERROR
CONNECT 1200
NO DIAL TONE
BUSY
NO ANSWER
CONNECT 2400
CONNECT 4800
171