Download Simrad PI54 A Specifications

References
Surface temperature alarms
This dialogue allows you to define alarms related to the surface
temperature. In order to enable these alarms, your system must
have relevant sensors fitted.
GAIN-
Alarm minimum:
Alarm maximum:
Shear alarm:
MENU
GAIN+
Surface temperature
00.0°C OFF
12.0°C ON
02.0°C/min OFF
Exit
(CD11103W-B)
The surface temperature sensor has individual alarm settings for
maximum and minimum temperature. To enable an alarm, you
must define the appropriate limits, and set it to ON. If the alarm
is triggered an audible signal will be provided, and a message
will tell you that the surface temperature alarm was set off.
Once an alarm has been triggered, it is automatically disabled
for 20 seconds. After this time it may be triggered again unless
the alarm situation has been rectified, or you have disabled the
alarm. The Shear alarm will be triggered if the temperature
changes faster per minute than the value you have entered.
Alarm maximum/minimum: To enable the temperature
alarms, select upper and lower limits, and then switch On.
Shear alarm: This alarm triggers if the temperature changes
faster per minute than the limit value provided.
Related topics
→
850-165186 / Rev.B
How to define alarm limits, page 97
213