Download Simrad PI54 A Specifications
Transcript
Sensor chargers PS30 Charger Purpose The PS Charger is a battery charger for secure charging of the PS and PI sensors. Daily operation 1) Attach the charging clamps to the sensor as follows: Red clamp: Positive fastening lug (+) Black clamp: Negative fastening lug (-) 2) Ensure that attachment materials, rope etc. does not short circuit the charging lugs, preventing charging and causing damage to the sensor lugs. 3) Observe the sensor’s indiactor lamp. It will flash once every four seconds during charging. 4) Observe the charge times and temperature limitations: Normal charge: ~16 hours for full battery capacity. Charging temperature: To obtain best results, try to keep the ambient temperature between +10°C and +25°C. The sensor must not be charged in temperatures above +50°C or below 0°C! Warning: 850-165186 / Rev.B Charging a sensor at sub-zero temperature might develop explosive gases representing a potential danger. Simrad assumes no liability for improper charging, or the use of other chargers than those approved by Simrad. 167