Download Siemens BH17 7ER Installation guide

Mobility and Logistics, Traffic Solutions
Sopers Lane, Poole, Dorset, BH17 7ER
4.11 Racks
The Stratos Outstation can also be ordered in either an 11” or 19” 3U rack and optionally
an associated 2U tray where other equipment such as detectors and routers can be
mounted. For information on routers and mounting refer to the IP router installation guide
(667/CI/45025/000)
Table 22 below gives an indication of the space requirements for typical equipment to be
mounted in the 3U racks. The numbers displayed are the maximum that can be fitted into
an 11" or 19" rack.
11" Rack Combinations
Stratos Outstation
1
1
1
48-16 I/O Board
0
1
2
IDB
0
0
0
Single Detector
2
2
2
19" Rack Combinations
Stratos Outstation
1
1
1
48-16 I/O Board
0
1
2
IDB
2
2
2
Single Detector
2
1
0
TC12 adaptor is the same width as a 48-16 I/O board
1
3
0
1
1
3
2
0
Table 22 – Rack Population Guide
If the unit is a standalone configuration in an 11" or 19" rack, detector blanking panel kits
are available to fill unused rack space. These are available in three widths as shown in
Table 23 These three combinations allow all unused rack space to be covered. The
standard top level assembles are fitted with the required blanking panels.
Description
Part Number
Single Detector Blanking Kit – Fills a single detector slot
667/2/31615/000
I/O Blanking Plate Kit – Same width as an I/O Board front panel
667/2/50071/000
Wide Detector Blanking Kit – 168mm wide panel
667/2/50072/000
Table 23 – Rack Blanking Plates
Security classification Unrestricted
Page
49 of 84
Version
1
Status
Issued
Last Editor
Carl Rabe
Date
11-Dec-2014
Document Name
Stratos Outstation General and ICM Handbook Document No. 667/HB/52250/000
Copyright © Siemens plc 2014. All Rights Reserved. Mobility and Logistics is a division of Siemens Plc