Download Roper 8575348 Specifications
Transcript
Option 2, No waste disposer Option 2. Attach drain hose to air gap with large spring-type clamp. If the drain hose was cut, use a 1-1/2" to 2" (3.8 to 5 cm) screw-type clamp s, Use a rubber type clamps* if needed air gap: Cut end of drain section). 3. hose - with 1. (do not cut ribbed No waste Cut end section). 2. Attach of drain drain disposer hose hose (3.8 to 5 cm) - no air gap: if needed to waste screw-type (do not cut ribbed tee with clamp 1-1/2" to 2" s. This connection must be before the drain trap and at least 20" (50.8 cm) above the floor where dishwasher will be installed. It is recommended that the drain hose hose connector* with spring or screwto connect air gap to waste tee. This connection must be before the drain least 20" (50.8 cm) above the floor where will be installed. 4, 1. be looped up and the counter. trap and at dishwasher securely fastened to the underside of drain hose drain hose_cut here if needed _ cut here if needed rubber hose connector __ large spring-type screw-type clamp waste tee drain hose drain trap r' Parts available Option from local plumbing 3, Waste disposer 1. Remove the disposer drain hose. 2. Attach drain type clamp. hose drain hose to disposer plug. Do not cut end of inlet with large be looped up and securely fastened the counter. large spring-type clamp to the underside Option1, _ from _ drain hose local plumbing drain hose supply stores there connection Direct HelpfulTip: route wire wire method: Wiring into the the dishwasher cabinet opening will be easier if you from the right side. of 1. Drill a 3/4" (1.9 cm) hole in right-hand cabinet side, rear or floor. Preferred and optional shown. drain hose 2. disposer inlet locations optional locations preferred locations are Wood cabinet: Sand hole until smooth. Metal cabinet: Cover hole with grommet, not provided. 3. Run wire into house wiring 4. Install a U.L-listed/CSA-certified clamp connector (strain relief) for flexible-type wire. If installing conduit, attach a U.L.-listed/CSA-certified conduit connector to the junction box. drain trap Insert drain hose through hole cut in cabinet to the front center of opening where drain connection will be made. ] Prepare cabinet opening where are no existing utility hookups Electrical spring- This connection must be before the drain trap and at least 20" (50.8 cm) above the floor where dishwasher will be installed. It is recommended that the drain hose 3. _ I I stores - no air gap: knockout "_ I Insert drain hose through hole cut in cabinet to the front center of opening where drain connection will be made. r' Parts available supply "_ JII dra,n trap 3. Insert drain hose through hole cut in cabinet to the front center of opening where drain connection will be made. [ [_ kJ waste tee 4. ' drain hose 5. Run other end of wire through cabinet hole. Cable must extend to the right front of cabinet opening. junction box.
This document in other languages
- français: Whirlpool GU2451XTSQ0