Download Savin SDC306 Operating instructions

Installation and Operating Instructions
11.5 Basic system diagram 5:
1 collector array, 1 storage cylinder, solid fuel boiler, return line monitor
System 5 has one collector surface, one
thermostat) and the return line temperature
storage cylinder, one solid fuel boiler and
increase
(temperature
difference
one return line monitor. The control unit
regulation). Heat metering is also possible,
controls the solar function (temperature
e.g. using an impeller flow meter.
difference regulation), the solid fuel boiler
(temperature
difference
regulation,
FSK = solid fuel boiler
Info
I
Current collector temperature (E1)
Minimum collector temperature (E1)
Maximum collector temperature (E1)
Current storage temp. at bottom (E2)
Minimum storage temp. - bottom (E2)
Maximum storage cylinder
temperature at bottom (E2)
Current solid fuel boiler temp. (E3)
Minimum solid fuel boiler temp. (E3)
Maximum solid fuel boiler temp. (E3)
Current storage cylinder temperature
at centre (E4)
Minimum storage cylinder temperature
at centre (E4)
Maximum storage cylinder
temperature at centre (E4)
Current return line temperature (E5)
Minimum return line temperature (E5)
Maximum return line temperature (E5)
Flow rate ∗
Daily yield ∗
Total yield ∗
Program
I
Maximum temperature of
storage cylinder
Solar circuit Td start
Solar circuit Td stop
R2 Td start
R2 Td stop
R3 Td start
Manual operation
I
Pump A1 off/on
Basic setting
I
Code entry
A2 off/on
A3 off/on
A4 off/on
Reset/factory setting
Select basic configuration
Max. collector temp.
Mode yield metering
Volume flow ∗
R3 Td Stop
Set time
DFG/WMM ∗∗
Glycol type ∗
Glycol percentage ∗
Min. temperature for boiler
Maximum temperature for
boiler
Maximum temperature for
return line
Code change
∗ Displayed only if yield metering mode is equivalent to 1 or 2.
∗∗ Displayed only if yield metering mode is equivalent to 2.
SDC 306
1316BED036-11B-E
- 36 -
Date 06/09