Download ASTi Telestra User guide

ASTi Telestra User Guide (Ver. 2, Rev. L.1)
The “default.cfg” File
To allow remote management, the “default.cfg” file loaded by the Model Builder software should
contain the following line:
CELL=ON
While you may find that the DACS system works with RMS without the “cell=on” directive, its
inclusion is still recommended, since later releases of Model Builder may have different default
settings.
Network settings that specify the following hardware parameters should be removed—or disabled by placing a semicolon (;) as the first character of the line—from the “default.cfg” file:
• Number of ethernet cards
• DIS/HLA ethernet card
• local IP address
• subnet mask
• gateway IP address
• Host ethernet card
• local IP address
• subnet mask
• gateway IP address
These settings should now be specified in the “config.sys” file, described in the next section.
IMPORTANT: Specifying the above hardware parameters in the “default.cfg” file will override
similar settings in the “config.sys” file.
All other network commands (port settings, DIS or HLA settings, etc.) should continue to reside
in “default.cfg”; this has not changed.
See Appendix A for an example installation.
18
Copyright © 1999-2006 Advanced Simulation Technology inc.