Download Carrier Access Network Device Axxius 800 User manual

CLI Commands
set
frame
framing
gennum
id
line
location id
loopdetect
payload
portnum
protect
5-84
Set the DS3 frame PMDL ID string
Command syntax: set {ds3-addr} frame {"string"}
{"string"} = transmission vendor’s identification, up to 10 characters,
enclosed in quotes.
Set the DS3 framing type
cbit
To C-bit framing
m23
To M23 framing
Set the DS3 generator number PMDL string
Command syntax: set {ds3-addr} gennum {"string"}
{"string"} = transmission vendor’s identification, up to 38 characters,
enclosed in quotes.
Set the DS3 ID.
Command syntax: set {ds3-addr} id {"id-name"}
{"id-name"} = up to 30 characters, enclosed in quotes.
Set a line loopback on the DS3.
loopdown
Disable loopback on the DS3
loopup
Enable loopback on the DS3
Set the DS3 location PMDL ID string
Command syntax: set {ds3-addr} location id {"string"}
{"string"} = transmission vendor’s identification, up to 11 characters,
enclosed in quotes.
Set detection of loopback requests
off
Disable detection of loopback requests
on
Enable detection of loopback requests
Set the payload loopback on the DS3
loopdown
Disable the payload loopback
loopup
Enable the payload loopback
Set the DS3 port number PMDL string
Command syntax: set {ds3-addr} portnum {"string"}
{"string"} = transmission vendor’s identification, up to 38 characters,
enclosed in quotes.
Set port protection on the DS3
off
Disable port protection of loopback requests
on
Enable port protection of loopback requests
Axxius 800 - Release 2.2