Download Velocity Edge DualX Technical data

Transcript
Section 5: Startup and meter configuration
August 2014
Reference, Installation, and Operations Manual
3-9000-743 Rev U
2.
Choose a Flow Calibration Method:
•
Polynomial
•
Piece-wise linear
•
None
3.
Enter the appropriate forward and reverse meter factors and click the Write button to
send the factors to the meter.
4.
Click the Cancel button to close the dialog box. If you made changes, click the Write
button to apply the changes.
After the meter is configured, set S-2 Position 4 (on the CPU Board) back to the open
position to write-protect the configuration.
164
Set calibration parameters