Download EdilKamin POWER Technical data
Transcript
sk tecnica Multilingua TINY_KELLY cod 665980 _definitiva x stampa.qxp 24/06/2011 9.56 Pagina 32 The TINY pellet stove is equipped with SISTEMA LEONARDO®. LEONARDO® is a combustion safety and control system which allows optimal performance in all conditions. This is a safety system that allows optimum operation in all conditions. LEONARDO® ensures excellent operation thanks to two sensors measuring the pressure level in the combustion chamber and smoke temperature. The detection of and subsequent optimisation of these two parameters is continuous in order to correct operation anomalies in real time. The LEONARDO® system offers constant combustion, automatically regulating the draft based on the characteristics of the chimney flue (bends, length, shape, diameter, etc.) and environmental conditions (wind, humidity, atmospheric pressure, installations at high altitude, etc.). The standards for installation must be respected. LEONARDO® system is also able to recognise the type of pellets and automatically adjust the flow moment by moment to ensure the required level of combustion. ELECTRONIC CIRCUIT BOARD KELLY wiring diagram wiring diagram G RS232/AUX M N SOS AUX FLOW SENSOR THERMOCOUPLE ELECTRONIC CIRCUIT BOARD TINY H L SENSOR AIR AMBIENT SMOKE THERMOCOUPLE SMOKE RPM IN T° J F R IN T° J SENSOR AIR AMBIENT (optional) RS232/485 SERVICE SMOKE RPM Vacuum gauge SENSOR AMBIENT P2 RS232 P1 BACKUP BATTERY LITHIUM CR2032 FUSE 2AT FUSE 2AT P B C FLOW SENSOR Smoke expulsion motor CONSOLLE BACKUP BATTERY LITHIUM CR2032 Reading points A D I/O CONSOLLE 230 Vac power supply M SCREW 50 Hz +/-10% INGNITION ELEMENT Smoke expulsion motor VENTILAZIONE INGNITION ELEMENT TM 230 Vac POWER SUPPLY 50-60 Hz +/-10% F TM 150 °C VENTILATION M SCREW SERIAL PORT The Dealer can install an optional on the AUX outlet for controlling the process of switching on and off (e.g. telephone remote, local thermostat), located at the rear oh the stove. Can be connected via special optional trestle (TINY code 621240 - KELLY code 620550). The serial port is located inside the stove on the lefthand side. BACKUP BATTERY A backup battery is found on the control board (3-Volt CR 2032 battery). Its failure (not considered a product defect, but normal wear and tear) is indicated with the words "Battery check" for the TINY model and "Batt. 1 - Batt. 2" for the KELLY model. For more detailed information, please contact the DEALER who has performed the first 1st ignition. ROOM TEMPERATURE SENSOR An outlet for the 1 metre-long room temperature cable is provided on the back of the stove. The sensor, which will be attached to the wall using the bracket provided, is wired onto the end of the cable. 31 ENGLISH FEATURES