Download Cabletron Systems SmartSwitch 8000 User guide

Transcript
Switch Administration
Enter show
PNNIMetric
IP Routing
to view the newly created metric pair:
SmartSwitch # show pnnimetrics
Metrics(ALL)
:
Metrics Metrics Tag Direction Index
GCAC CLP Admin Wt Service Categories
================================================================================
1
0x9
Incoming 0x10
CLP0+1
200
CBR
2
0x9
Outgoing 0x10
CLP0+1
200
CBR
3
0x111113
Outgoing 0x1
CLP0+1
5040
UBR
4
0x111113
Outgoing 0x2
CLP0+1
5040
ABR
5
0x111113
Outgoing 0x4
CLP0
5040
NRTVBR
6
0x111113
Outgoing 0x18
CLP0
5040
CBR RTVBR
7
0x111114
Outgoing 0x1
CLP0+1
5040
UBR
8
0x111114
Outgoing 0x2
CLP0+1
5040
ABR
9
0x111114
Outgoing 0x4
CLP0
5040
NRTVBR
10
0x111114
Outgoing 0x18
CLP0
5040
CBR RTVBR
SmartSwitch #
The newly created metric pair appears at the top of the list.
Once the metric is created, we can specify its metric tag number within the definition of a route:
SmartSwitch # add atmroute
PortNumber(A1)
AtmAddress()
PrefixLength(104)
Index(0)
Type(Internal)
Scope(0)
MetricsTag(0)
SmartSwitch #
: b2
: 39:00:00:00:00:00:00:00:00:00:55:77:88
:
:
:
:
< The index tag of our metric pair
: 9
Administrative Weight and Parallel Routes
A route’s administrative weight defines its desirability to the PNNI routing service with regard to computing a path to
a particular location. The lower the administrative weight, the more desirable the route. For example, a route with
administrative weight 200 is considered a better route than one with the default weight of 5040. As a result, the
administrative weight provides a quantitative way to control which routes are favored for call set up.
The ability to control the PNNI routing service in this fashion allows for parallel routes into an IISP domain to be
weighted such that one route is designated as the default, while the other becomes the backup route. This
default/backup routing topology is typically used where a link to a particular domain requires a high degree of
reliability. If the default route becomes congested or reaches its bandwidth limit, the routing service can initiate load
sharing by routing additional calls through the backup route.
4.3
IP ROUTING
The SmartSwitch 9A100 switch provides limited IP routing. IP routing allows switches that are not connected directly
to Ethernet to communicate with an Ethernet-based network management system (NMS). The connection is made by
adding IP routes on the non-connected switches that specify a client on a connected switch as their gateway to the
Ethernet.
SmartSwitch 9A100 User Guide 4-7