1
Download McDATA OPENconnectors Command Line Interace User manual
Transcript
config 2 Parameters Command Example Output Output Example This command has no parameters. config security ssh show The output of the config.security.ssh.show command displays the following data: SSH Indicates if the SSH interface to CLI is enabled or disabled. Telnet Indicates if the Telnet interface to CLI is enabled or disabled. SSH: Telnet: enabled disabled config.security.switchAcl The access control list (ACL) feature allows a user with appropriate rights to configure a set of IP addresses that are allowed to make an IP management connection to the product. config.security.switchAcl.addRange Syntax Purpose Parameters addRange startIPAddress endIPAddress This command adds a new range of IP addresses to the access control list. This command has the following parameters: startIPAddress The starting IP Address of the desired range. The address must be entered in dotted decimal form (such as, 10.0.0.0). endIPAddress The ending IP Address of the desired range. The address must be entered in dotted decimal form (such as, 10.0.0.0). The maximum number of entries in this command is 32. 2-62 Enterprise Operating System Command Line Interface User Manual
