Download McDATA OPENconnectors Command Line Interace User manual

config
2
config.zoning.addWwnMem
Syntax
Purpose
addWwnMem zoneName wwn
This command adds a WWN zone member to the specified zone in
the work area.
NOTE: A product can have at most 1024 zone members in its zones.
NOTE: The ED-5000 supports a maximum of 512 zones.
Parameters
Command Example
This command has two parameters.
zoneName
Specifies the name of the zone.
wwn
The WWN of the member to be added to the
zone. The value of the WWN must be in
colon-delimited hexadecimal notation (for
example, AA:00:AA:00:AA:00:AA:00).
Root> config zoning addWwnMem TheUltimateZone
10:00:00:00:C9:22:9B:64
config.zoning.addZone
Syntax
Purpose
addZone zoneName
This command adds a new (empty) zone to the zone set in the work
area.
NOTE: Changes are not activated on the switch until the
config.zoning.activateZoneSet command is issued.
NOTE: A zone set can have a maximum of 1024 zones.
NOTE: A Switch or Director can have a maximum of 1024 zone members in
all of its zones, except for the ED-5000, which allows a maximum of 512
zones.
CLI Commands
2-87