Download McDATA OPENconnectors Command Line Interace User manual

Transcript
A
Message
Description
Action
Message
Description
Action
Message
The feature key entered is invalid.
Verify that the feature key was entered correctly and re-submit.
Contact your service representative with further difficulties.
Error 239: Fabric binding entry not found
The user requested to remove a fabric binding entry that is not in the
pending fabric membership list.
Verify that the correct entry (both WWN and Domain ID) is being
requested for removal from the list and re-submit the request.
Error 240: Duplicate fabric binding member
Description
The user requested to add an entry to the fabric binding list that is
already a member of the list.
Action
Verify that the correct entry (both WWN and Domain ID) is being
requested for addition to the list and re-submit the request.
Message
Description
Error 241: Comma-delimited mode must be active
Comma-delimited mode must be active to execute this command
Action
Some commands require that comma-delimited mode be active (e.g.
show.nameserverExt). Enable comma-delimited mode and re-issue
the command.
Message
Error 244: Not allowed when Enterprise Fabric Mode is Active and
Switch is Online
Description
This operation is not allowed while the switch is in Enterprise Fabric
Mode and the switch is Online.
Action
A-38
Error 238: Invalid Feature Key
Make sure Enterprise Fabric Mode is not enabled and the switch is
offline.
Enterprise Operating System Command Line Interface User Manual